EMCS Functions Quick Guide
Enable EMCS
Key Off
Cruise Off
Key On (Engine OFF)
Cruise On
Turn the ignition to the off position.
Turn the cruise control to the off position.
Turn the ignition to the on position but do not start the car.
Turn the cruise control to the on position.
Unlock ECU or Disable Anti-Theft
EMCS must be enabled.
Enter Digit (Speed- Down)
Register Digit (Cancel - Push away from you)
Push the cruise control down to Speed- and let go corresponding to the digits of your security code.
Example: If your first digit is 5, Push Speed- and let go 5 times.
Push the cruise control away to Cancel to register the digit.
Repeat step 1 and 2 for each digit in your security code.
Example: If your code is 5-2-3-2
Digit 5: Down, Down, Down, Down, Down
Register 5: Away
Digit 2: Down, Down
Register 2: Away
Digit 3: Down, Down, Down
Register 3: Away
Digit 2: Down, Down
Register 2: Away
The EPC and CEL will flash back and forth when you have successfully entered your security code!
Select Program
EMCS must be enabled and unlocked.
Hold Speed- Down
1-4 Blinks Per Second
Release
Confirmation*
Hold Speed- Down.
The CEL will blink, pause and repeat.
- Program 1 - 1 blink
- Program 2 - 2 blinks
- Program 3 - 3 blinks
- Program 4 - 4 blinks
When it's flashing the number of times per second equal to the program slot you want, release the Speed- button.
*Only Some Models
The EPC light blinks 1 to 4 times indicating the program you selected.
If you get this confirmation, skip the steps below. You may start the car and go.
Key Off (10 Seconds)
Key On (Engine Off & Wait)
Key Off
Key On
Turn the key to the off position and wait 10 seconds.
Turn the key to the on position and wait till the EPC and CEL stop flashing.
Turn the key off.
Turn the key on and go!
Lock ECU
EMCS must be enabled and unlocked.
Hold Speed+(Push Up)
3 Blinks Per Second
Release
Confirmation
Push and hold the Cruise Control lever up for Speed+.
The CEL will flash, pause and repeat.
Let go of Speed+ when the CEL is flashing 3 time per second.
The EPC and CEL will flash back and forth to confirm the ECU is locked out.
Enable Anti-Theft
EMCS must be enabled and unlocked. No more than 1.5 seconds can elapse between each step below. This may be preformed with the vehicle running.
Speed-
Speed-
Speed+
Speed+
Push Speed- Down.
Push Speed- Down.
Push Speed+ Up.
Push Speed+ Up.
Speed-
Speed-
Speed+
Speed+
Push Speed- Down.
Push Speed- Down.
Push Speed+ Up.
Push Speed+ Up.
Confirmation
The CEL will flash indicating anti-theft is enabled. Anti-Theft will run the next time the key is cycled.
Run Fault Code Erase
EMCS must be enabled and unlocked.
Hold Speed+(Push Up)
1 Blink Per Second
Release
Push and hold the Cruise Control lever up for Speed+.
The CEL will flash, pause and repeat.
Let go of Speed+ when the CEL is flashing 1 time per second.
Run Throttle Body Alignment
EMCS must be enabled and unlocked. Engine must be cold. Only available on 1.8T, 2.7T, 4.2T, 24V VR6 and first generation 3.2L VR6.
Hold Speed+(Push Up)
2 Blinks Per Second
Release
Push and hold the Cruise Control lever up for Speed+.
The CEL will flash, pause and repeat.
Let go of Speed+ when the CEL is flashing 2 time per second.
